high temperature resistant ceramic epoxy resin coatings

Product usage:
the temperature rises, the ceramic precursor transforms into polymeric ceramic material through pyrolytic ceramization reaction, and finally forms a solid ceramic protective layer on the substrate.The product is cured at room temperature and has
a maximum temperature resistance of 500℃. It is used to protect the metal surface such as high temperature flue against oxidation, corrosion and erosion wear.
 
Performance feature:
1.high temperature resistance, not fall off and not crack;
2. Flue gas corrosion resistance and fine powder erosion resistance;
3. It has high bonding strength with metal substrate.
 
Performance index

 
How to use:
1, surface treatment: clean the pending-repair part,exposing the fresh substrate and rough treatment, the treated surface should be clean, dry, rough and fresh material surface;
2, preparation: according to the weight ratio A:B=1:1~1:1.5 (recommended dosage A:B=1:1.2) take the right amount of A, B two components mixed and stirred evenly, the mixed prepared material should be used up within the specified operating time;
3, coating: spray or brush the mixed prepared material on the parts to be repaired,the film thickness should be less than 200um(i.e. 0.2mm), each kilogram can cover about 3 square meters of the substrate surface;
4, curing: after the completion of the construction,it need to be placed for more than 24 hours to be fully cured before the coating can be put into use (when the temperature is below 10℃,should prolong the curing time or heating curing).
 
Matters need attention:
1. All the parameter data marked in this material are obtained by our laboratory or commissioned by a third party for testing. We strive to make these parameter data accurate and reliable. However, due to the complex and diverse actual working conditions,
the parameter data in this material is only for users' reference, not as a basis for purchase.At the same time, it is suggested that the user simulate the real working condition before use and make pre-use prediction test, so as to judge whether the product is
suitable for the actual working condition.
 
2. The usage method in this document is only a general guiding scheme. Before the formal construction, please determine the appropriate construction scheme according to the actual working conditions on the site
 
3. This product should be constructed at the ambient temperature above 0℃.
 
4. Must wait for the coating completely dry,the equipment can be put into normal operation, otherwise it will affect the service life of the coating.
 
Packing specification:
Packed in a plastic drum, 10Kg/set, two components.
 
Transportation storage:
1.Sealed storage in the cool and dry place.The warranty period is 12 months.
2.Avoid placing it upside down,knocking against and transporting it as a non-dangerous product during transportation.