Keywords: slurry pump abrasion,slurry pump repairing,slurry pump wear resistant protective material.
Maintenance workpiece:slurry pump guard plate,slurry pump guard jacket.
Material: high chrome alloy.
The condition before repairing: perforated scrapping part.
Material selection: BD7021 super wear resistant coating,BD426T special undercoat.
Construction tools: angle grinder,wire brush,grinding wheel,plaster knife,plastic knife,rubber hammer,special rounding tools,hair brush,electronic scale,drying oven.
Auxiliary materials: cleaning agent,duster cloth,gloves.
Construction technology:
1.Clean up and polish the pending-repair workpiece on the needing-repair part,clean it by cleaning agent and dry it by the airing.
2.Weigh A and B component of BD426T special undercoat according to the specified ratio and mix them uniformly,and brush coating on the pending-repair part,then wait for the primer curing,when the temperature is low,can heat it up to promote the primer curing.
3.Weigh the BD7021 super wear resistant coating according to the specified ratio and mix it uniformly,make the mixture uniform materials be coating on the pending-repair part,knock on it to be compacted with rubber hammer,repair the surface of adhesive layers to be smooth with special rounding tools,make the surface to be flat and smooth.
4.Curing:BD7021 super abrasion resistant coating can be initial curing at room temperature,after initial curing,heat it up to the temperature of 100‘ζ slowly and keep this temperature for 2-3 hours,only in this way,it can improve 40% combination property.Generally it can exceed the working life of new pump.
5.Brush coating the topcoat.
Material utilization amount: 12Kg BD7021 super wear resistant coatings, 1Kg BD426T special undercoat.
