wear resistant ceramic adhesiv > high strength epoxy anti wear ceramic tile bonding adhesive

high strength epoxy anti wear ceramic tile bonding adhesive

BD99 high strength epoxy ceramic tile abrasion wearing resistant bonding adhesive

Packaging specification
Two components,10kg/set (Component A: 5Kg + Component B: 5Kg),plastic drum + carton packaging.

Product description:
This product is the paste epoxy,also called ceramic tile bonding agent,high bonding strength ceramic tile adhesive,used for bonding of all kinds of building inside and outside wall surface ceramic tile.Its main features
are high bonding strength,good water resistance, good freeze-thaw resistance, good aging resistance and convenient construction.

How to use
1. Surface treatment: clean the surface to be bonded;
2. Gluing: mix the two components evenly according to A: B(weight ratio)= 1:1;
3. Sizing: evenly apply the adjusted glue to the surface of the ceramic tile and then press it on the wall surface.
4. Curing: the complete curing time of the adhesive layer is 24 hours at room temperature.The curing speed of the adhesive layer will be accelerated when the ambient temperature is high,the adjusted glue should be
used up before usable time.

Performance index:

The curing characteristic table of BD99 epoxy ceramic tile bonding adhesive (test condition:temperature: 20-25℃,Relative humidity:55
Physical state	Density (g/cm³)	Compressive strength (Mpa) GB/7124-2008	Shear strength (Mpa) GB/1041-2008	Impact strength (J/cm²) GB6328-1999
Paste	1.5	73	17	41

Coating time limit (min)	Curing time	Working temperature (℃)	The highest temperature resistant (℃)
30～60	Room temperature:24 hours or room temperature 1 hour+60℃2 hours	-60～100	120

Special version:
1.The product parameter is obtained for laboratory testing,only for reference,due to the actual working condition is more complex,suggest the users to do the pretest according to actual working condition.
2.When the environment temperature is below 15℃,the curing time will prolong,should take proper heating measure,when the environment temperature is more than 30℃ or the mixing quantity is too large,the curing speed will expedite,
should properly shorten the application time of coating after mixing.
3.The base surface should be firm, dry, clean and flat, without greasy dirt,without dust,without release agent and other loose materials.Construction wall surface should maintain a certain degree of flat,uneven or extremely rough
parts should use the cement mortar and other materials for leveling.

Transportation storage
Sealed storage in the cool and dry place.The warranty period is 12 months.Keep away from dangerous sources during storage and transportation.Avoid placing it upside down, knocking against and transporting it as a non-dangerous
product during transportation.

------分隔线----------------------------